Installation of the detection loop wires and cabling ...

1. The activated detection loop is sensitive to interference, sometimes emitted by nearby cables. When possible, keep other cables 5 m (15 ft) away. Also make sure karts on other parts of the track will not get closer than 5 m (15 ft) to the detection loop, to avoid false inputs.

2. Finish the installation of the activated detection loop by powering it. The activator will tune itself when the power is supplied. To tune your activator, please follow this steps:

   • Connect all cables (loop wires, coax)
   • Switch on the enclosed power supply (13,6 VDC)
   • Green LED will start blinking and you will hear the activator ticking.
   • When the ticking stops the activator is tuned
   • The green LED must indicate green continously.

   When the activator is tuned, the green LED must indicate solid green. When the green LED is blinking, the activator is not tuned correctly. This can be caused by these problems:
   

   • - The power supply was connected first: Make sure that you first connect the loop with the activator before you connect the power supply.
   • - No loop wires are connected: Make sure you connect all cables including the loop wires.
   • - The loop wires are broken: Replace the broken loop wire
   • - The activator is not working properly: First check the power supply, when your activator is still not working, please contact AMB